Products For engines

For a gasoline engine		For a diesel engine

• restoration and protection against wear of the rubbing parts;
• restoration of the geometry of the parts;
• 100-300 times reduction of the friction coefficient;
• fuel savings in the idling cycle up to 30 %;
• increased oil pressure;
• equalized and increased compression in the cylinders;
• bringing the engine power up to 100%;
• 10 times lowered noise and vibration levels;
• possibility of operation after an accidental oil loss up to 300 km;
• 2-10 times reduction in CO è CH contents of the exhausts ;

• the engine need not be disassembled;
• improved operation of the engine after 50-100 km already.

The effectiveness and serviceability of the engine to a great extent depends not only on the conditions of the engine itself, but on many other factors, processes and mechanisms, accompanying, participating and influencing its operation. For example, the high oil consumption can be caused not only by considerable wear of the engine parts, but by the non-tightness of the gaskets, gland wear, sticking of the piston rings in the cylinder. Therefore, when making a decision to treat the engine, first of all pay attention both to the characteristic indicators of wear, and to general symptoms. For example:

• hollow low pings from the crankcase bottom, which intensify noticeably, when the crankshaft rotational speed is increased (wear of the main bearings);
• steady ringing metal sounds, which intensify with increased loading (wear of the crankpin bearings);
• engine overheats;
• muffler smokes;
• power loss;
• high fuel consumption;
• low pressure and high oil consumption;
• intense vibration and noise.

Opportune and efficient is the treatment of normally functioning and new engines. The amassed experience of application of XADO speaks in favour of the necessity for an early preventive treatment of such engines. In this way new parts get run-in, while those with slight wear, get quickly reconditioned. Due to an abnormally low friction coefficient of the protective coating being formed, internal loads on the engine parts diminish, which considerably prolongs its service life. And then, in case of any mulfunctions, their causes should be looked for "on the surface": carbureter, ignition system, fuel quality.

An important aspect of using oils should be noted. For the treated engines the quality and grade of the oil are of no importance, as the oil no longer acts as a lubricant, and "works" as a fluid, contributing to a uniform distribution of the heat across the engine parts.

STAGE I

1. Squeeze out the contents of 1 tube into the oil filler neck of the engine.
2. Start the engine and allow it to idle for 30 min.
3. Drive 15-20 km with a minimal load (maximum 2700 r.p.m.)

STAGE II

1. Perform after a 100-250 km run following the same procedure (this value must not be exceeded !)
2. It is possible to perfor the treatment after 5 h of idling (equivalent to a 100-250 km run).

Note. 2 stages are sufficient for new motor cars (2 tubes).

STAGE III

1. Perform after a 100-250 km run following the same procedure (this value must not be exceeded !)
2. After a total 2000-2500 km run from the beginning of Stage I the treatment is considered complete.

The dosage of XADO depends on the oil system capacity, which in turn is proportional to the area of the rubbing mates. Dosage examples...

To facilitate determination of type, quantity and procedure of employment of gel tubes for treatment of your motor car, we have developed certain methods for standard car models. Methods...