Products For transmission gearboxes, transfer gearboxes and reducers

• reconditioning and protection against wear of the rubbing parts;
• restoration of the geometry of the parts;
• elimination of pits and scratches on the working surfaces;
• 100-300 times reduction in the friction coefficient;
• considerable fuel savings on all-wheel-drive vehicles;
• 10 times reduction in noise and vibration;
• possibility of protracted service (up 1000 km) after an accidental oil leakage.

• disassembly is not required;
• universality;
• fast effect.

Although the gearbox will not break very often, its repair and disassembly are complicated and costly operations, especially, when an automatic gearbox is concerned. Overheating, difficult shifting of gears, grinding sounds from the gearbox or noise from the reducer can still be "healed" with the aid of XADO, but it's better to take preventive measures, not waiting for the symptoms of illness to show up.

Attention. Prior to treatment of a automatic gearbox advice of a professional must be sought.

1. Into a transmission gearbox, transfer gearbox or rear axle reducer XADO should be introduced via an oil fill opening in the amount of 1 tube per 1.5 l of oil (see thetable).
2. Immediately after the introduction of XADO drive about 10 km, including 100-300 m in the reverse.
3. The treatment is considered complete after 100 h of the mechanism operation (a 3.000 km run).

Note. If after a 100-200 km run no improvement is observed, then the most probable cause of this is a diagnostic mistake. An inconsiderable improvement evidences intense wear of the mechanism, the recommended dosage should be doubled.